Buses first used before 1 April 1955 only need one rear position lamp. The lamp must be on the centre line or to the offside. End-outline marker lamps

Generate content: And voila! The last step is generating the final article. Seems like magic, right? There’s a reason it’s called a wizard. AI can’t read your mind (or can it 👀). Remember that even once you’ve thought of the key points, the generator can’t use them to inform the outline unless you explicitly input them. Structure and attachments - 6.1.7. Transmission - Defect (g) (ii) changed from 'missing, split, insecure or no longer prevents the ingress of dirt' to 'missing, split or insecure so that it no longer prevents the ingress of dirt' Press the brake pedal to light up the stop lamps and operate all the other lamps in turn to see if the stop lamps are adversely affected. DefectExhaust emissions - Opacity - Updated information when you cannot get a reading or the DSM shows an error. That’s where an outline generator comes in. It takes your thoughts and structures them to help you start off your content on the right foot. How does an outline generator work? Sometimes it is not easy to determine if the self-levelling systems work. In such cases you should give the benefit of the doubt.

|Passenger vehicles with 8 or more passenger seats (excluding buses and minibuses) M2| First used before 1 August 1978 | At least one mirror/device in any of the above positions vehicles with permanently disconnected, painted over or masked front and rear position lamps that are Headlamps - 4.1.1. Presence, condition and operation - The sentence 'You do not need to test headlamps on vehicles if:' and its following bullet points removed the mean smoke level from any consecutive 3 readings was at or less than the limit for the vehicle" Vehicles must have 2 front and 2 rear position lamps, except for tricycles or quadricycles that are less than 1,300mm wide.

You must inspect end-outline marker lamps on vehicles first used on or after 1 April 1991 that are wider than 2,100mm, excluding side mirrors. Generate talking points: After you’re happy with the sections, the next step is generating talking points. Under each section, the blog wizard will spew out a few main points. Similar to the outline step, you can edit or add to them. Structure and attachments - Coupling mechanisms and towing equipment - Applicable from 1 February 2021 - Defect (a) changed from 'A towbar component damaged, defective or fractured' to 'A towbar component damaged, defective, fractured or corroded'

How does an outline generator work?

Front and rear fog lamps - 4.5.4. Compliance with requirements - Sentence added 'Rear fog lamps may extinguish when main-beam is switched on or when dipped beam headlamps are switched off.'

Front and rear fog lamps - 4.5.3. Switching - Removed the sentence 'The function of a fog lamp must not be adversely affected by the operation of any other lamp.' Seat belt installation guidance notes - Changed bullet from 'mandatory seat belts as specified in Section 5.1 of this manual' to 'mandatory seat belts are specified in Appendix C of this manual' Front and rear position lamps, daytime running lamps and end-outline marker lamps - 4.2.3. Compliance with requirements - Sentence added 'A DRL is permitted to switch off when the same side indicator is operating.' This use case saves time and effort in manually organizing the content, allowing writers to focus more on the content itself. Ensure you include your keywords and also the goals for your content when inputting your information. The clearer you are on what you’re trying to create, the clearer the final outline will be. Teach the AIadded paragraph - "Not tested” or “Unable to be tested” must only be used where it becomes apparent during the test that the particular item cannot be tested, and this could not have been identified prior to starting the test. The reason for selecting the failure must be included in the additional information box.