Take 1 standard Bit Light (non flashing) and place it on top of the stud of the grey round plate ensuring the LED component part is facing the correct way up. Secure the LED in place by connecting the transparent Lego plate over the top.

Follow LeLightGo step-by-step instruction to light up your Ghostbusters ECTO-1, something amazing will happen at night. All our kits are plug and play - no electronics knowledge needed!Continue to remove the following pieces which make up the windscreen, side windows, and grey triangular tiles from the sides of the car.

Before dive into the KIT itself I have to remark, that the customer service was just fantastic before buying the KIT. I had some doubts and questions but they were just provided one of the best support online. Take the front grey pole with attached lights and disassemble all the pieces as we will be replacing the grey pieces with new pieces (with different clips). Ever wanted to create your own LEGO® set? That's exactly what LEGO® Ideas is! Fan-submitted creations have now been turned into actual commercially available sets!

This kit has not one, but two sound modules, and together these modules can play four sounds at the same time. This provides the most realistic sound possible, including: When installing Bit Lights under LEGO® pieces, ensure they are placed the correct way up (Yellow LED component exposed). You can either place them directly on top of LEGO® studs or in between. Locate 2 of the provided grey plates with clips as we will be replacing the original ones with these. Take another 2 flashing Bit Lights and install them by placing them over the studs and connecting the blue transparent round pieces over the top. Remove the front section with the grill and number plate attached, followed by the 2 Lego 2×4 plates with light pieces attached.

Take one of the provided grey Lego pieces with clip and place 1 standard Bit Light (non flashing) on top of the stud. Secure the LED in place by connecting the transparent red round piece over the top ensuring that the LED component part is facing the correct way up. Ensure the cable from the LED is facing the same way the clip underneath is facing Turn the roof on its side to allow you to then group all the cables from the front roof LEDs. Twist/wind them around each other, same way we did for the rest of the light cables.To ensure a trouble-free installation of your light kit, please read and follow each step carefully. If you want to control the lights and get a special sound kit, then it's best to get the Standard RC + Sound Version. However, both Standard RC + Sound, Standard Remote and Standard versions are a wonder to behold at the same time as they come with the same lights. ABOUT INSTALLATION