In some cases, the verge units are suitable for both left and right-handed verges – if this is the case, just remove the tab to make the verge suitable for the side you are working on. If not, just ensure you have the correct verge unit for the side you are working on. Problems in Roofing Design, B. Harrison McCampbell, Butterworth Heineman, 1991 ISBN 0-7506-9162-X (available used) Positioning: Determine the desired location along the roof edge for the roof cap. Ensure that the area is clean and free from debris or obstructions. If there is an existing end cap or damaged component, carefully remove it. Fit the eaves closure unit over the first tile in the eaves course. The eaves closure unit both prevents birds and water getting into the roof while also providing the fixing position for the eaves clip.

Rain blowing in and occasionally in some climates fine snow blowing into attics is a complaint we've gotten from time to time;Carefully position the second rapid verge unit in the upper and lower slots of the first unit. Slide the rapid verge unit, ensuring the upper and lower lugs are securely engaged, in the direction of the ridge until the tail of the unit lines up with the tail of the roof tile. Secure the head of the second rapid verge unit to the batten end clip as before. Continue in the same manner up the entire length of the verge to the ridge. Metal Edge Trim: Metal edge trims can be employed to finish the edge of roofing tiles. This involves installing a metal strip or trim along the roof edge, which provides a clean and defined aesthetic. Metal edge trims are available in various materials such as aluminum or stainless steel, and they can be customized to harmonize with the roof's style. They are often affixed using screws or adhesive, ensuring a secure and durable finish. Clip the first verge unit over the eaves closure unit, then slide it along until the end lines up with the edge of the roof tile. Once this is done, nail the top of the verge unit into the batten end clip. Step 6: Fit the eaves closure unit over the first tile. This will prevent the ingress of pests and water into the roof, but also act as a secure unit on which the eaves clips can be fixed. Step 4:

Degree of 'misalignment' in tiles that is OK with a curved roof for instance Chinese/Japanese roof would appeciated Reply: Finishing touches: Once the roof cap is securely attached, inspect the installation for any gaps or loose sections. Make any necessary adjustments or tighten any fasteners to ensure a snug and secure fit. Clean up any excess adhesive or debris from the installation area. The design of roof tile end caps focuses on seamless integration and alignment with the specific profile of the roof tiles employed. They are available in a variety of shapes, sizes, and colors, catering to diverse roofing styles and aesthetics, ensuring a harmonious blend. Marley’s collection of high-quality roofing accessories is extensive. Each product has been specifically designed to work in harmony with all aspects of the Marley roofing system and is fully compliant with BS 5534and NHBC guidelines. Our ventilated systems – dry hip, dry ridge and abutment – are all weathertight and economical to install. Additionally, Marley’s ventilation terminals provide for natural as well as mechanical ventilation, ensuring your roof system can breathe from the inside outwards.by Vermont Structural Slate Co., Inc., Fair Haven, VT 05743, 802-265-4933/34. (We recommend this book if you can find it. It Installing a roof cap involves a series of steps to ensure a secure and proper installation. Here is a general guide on how to fit a roof cap: At left our photo shows special ridge tiles on a home in New York state, including one broken tile that needs replacement. In this location leakage was minimal. Cutting (if necessary): If the roof cap requires trimming to fit the measured length, use appropriate cutting tools such as a saw or shears to carefully cut it to the required size. Follow any cutting instructions provided by the manufacturer, if applicable.