This cookie, set by YouTube, registers a unique ID to store data on what videos from YouTube the user has seen.

wedi Fixing Washers are reverse-countersunk, designed to fit flush with the surrounding board surface and facilitate the application of tiles and other surface finishes to the board. They prevent the fixing screws from penetrating the XPS foam core of wedi boards and greatly improve the holding strength of the screws into the substrate below. To protect the insulation fixing washer discs from corrosion they are galvanised. And this minimises almost any chance of degradation over time. A cookie set by YouTube to measure bandwidth that determines whether the user gets the new or old player interface. Records the default button state of the corresponding category & the status of CCPA. It works only in coordination with the primary cookie.

Each washer measures 35mm in diameter and the hole in the centre is countersunk, allowing it to be fixed flush with the surface of the board/panel when fixing it in place. The stainless steel washers are guaranteed not to rust and are for use in areas that are subject to high humidity or are constantly wet. Created with a perforated surface which will maintain a maximum board surface exposure because the washers have a metal surface. Metal surfaces are not designed to be fixed together with most standard adhesives and plasters as they will not adhere to each other. By strategically perforating the centre of the washer disks it allows the adhesive or plaster to adhere to the boards surface minimising any risks of the surface delaminating.

To protect the insulation fixing washer discs from corrosion they are galvanised and this minimises almost any chance of degradation over time. These strong, sturdy washes are all made with 100% Steel, and are the highest quality washers that you will find on the market. Not only extremely strong, they are 100% rust and corrosion proof and made to last. What You Will ReceiveCreated with a perforated surface which will maintain a maximum board surface exposure. Because the washers have a metal surface. Metal surfaces are not designed to be fixed together with most standard adhesives and plasters as they will not adhere to each other. By strategically perforating the centre of the washer disks. It allows the adhesive or plaster to adhere to the board’s surface, minimising any risks of the surface delaminating. Counter sunk to allow the screw head to pull into the board but the outer rim of the disc to remain flush with the board surface AddThis sets this geolocation cookie to help understand the location of users who share the information.