Upon cleaning off the excess marks it was found that once again the washing up liquid had proved to be the finishes achilles heal. With the Blanchon Original Wood Environment again there is a slightly different application process. Three thin coats are recommended, to be applied using a natural bristle brush or roller. In this case we have applied the Blanchon Original Wood Environment - Natural. CLEAR HARDWAX OIL MUST ALWAYS BE USED AS THE FINAL COAT WHEN NATURAL HARDWAX OIL OR COLOUR TONES ARE APPLIED*

Apply the 2nd coat using a good quality brush or microfibre roller. This coat must not be applied until the first coat is dry. Here at Treatex, we’re passionate about wood and its upkeep. This is why we specialise in a range of high-quality wood finish products that will protect your wood from damage while enhancing its already amazing natural beauty of it. We provide everything you need to finish, maintain and clean your wooden surfaces, so you can enjoy them for years to come. Thanks to our commitment to favouring natural ingredients over chemical ones, Treatex products contain no biocides or toxic chemicals and are safe to use on a wide variety of surfaces. Straight away from using this product it was immediately obvious that the finish had raised the grain, leaving a rough finish. The varnish finish also provided one of the roughest of those tested, only slightly smoother than the Blanchon Hard Waxoil.

Preparation and Application

Hardwax oil emboldens the natural beauty of wood, bringing out unique grain patterns and colours. It is available in a variety of colours and finishes, allowing users to achieve the desired look for their project. Eco-Friendly That leaves the Fiddes Hardwax Oil - Clear Satin and the Blanchon Hard Waxoil - Natural which, in our opinion, proved to be the best finish to use on your oak flooring. Once the first coat had fully dried, the second coat of primer could be applied. This was applied in exactly the same way as before. Treatex Hardwax Oil is available in two key models. Whilst both possess different properties, they both achieve consistently fantastic results. Treatex Hardwax Oil Ultra (Natural)

This combination was then applied to boards across and with the grain using a roller. Once dry, a further two coats were applied as before. The washing up liquid produced the most damage by quite literally stripping the finish off the board. The wash and care consisted of one full cap to one litre of water as per the manufacturer's instructions. Vinegar After a second wash, the board was generally free from any marks, although there was still a slight orange patch on the Osmo and Treatex sections of the board. Short Test - Blanchon Original Wood Environment As the only varnish to be tested it was always to be expected that the final finish would differ to the hard wax oils.After the washing up liquid proved to be the environments weakness in the previous test, it was interesting to see how it would react to the long test. Application of the first coats were all done under warm conditions where the sun was shining onto the board. These conditions remained the same for all of the finishes. Treatex Hardwax Oil Traditional - Clear Satin Both of our hardwax oils are formulated using only natural, sustainable ingredients and are sure to enhance and protect the natural beauty of interior timber surfaces. We are proud to offer eco-friendly wood preservatives that allow you to achieve the hard-wearing, easy-to-maintain, and aesthetically pleasing wood surfaces you desire. Where to Buy Hardwax Oil? One of the most prominent stains however, was from the washing up liquid, which left a mark even after cleaning. If you want to not only preserve your wood mantelpiece’s natural beauty, but also enhance and show it off, Treatex Hardwax Oil Ultra Clear is the product for you. This Hardwax Oil is a fantastic timber treatment, following the success of previous formulas whilst also improving upon them an ease of application and the durability of the finish.