Joined in 2023 
82 
63 About this deal
I had to adjust the physical Z-heights of my printer head as the original firmware went to the endstop and then went up a bit before printing, whereas Marlin goes to the endstops and then stays there before printing. There are several actions that could trigger this block including submitting a certain word or phrase, a SQL command or malformed data.
The related products of anet a8 motherboard: The hot bed power module is equipped with heat sink, a special heat sink and anodized aluminum alloy housing. I can't just Google anet a8 main board upgrade because there are so many different options to upgrade. The control module is embedded in a highprecision electronic components, such as lcd, sensor, led and other temperature resistant devices, to ensure that the quality of the printer is reliable to use. APPLICABLE MODEL: This motherboard is suitable for Anet A8 PLUS 3D printer, and can be directly connected to for Ramps1.
Can be used on any and all kinds of instruments, meters and sensor's installation is simple, which greatly improves the efficiency of the anode. I'm NOT asking for purchase advice, I'm looking for where to start or more information on the upgrade. I'm in a situation where I need to control current to the E stepper and am trying to figure out how. For the new LCD2004 or LCD 12864 to work it is very important to see the flat cable 180º of EXP1 and EXP2.
Do not redistribute any products before they have arrived with you as inventory may vary and/or items might need repairs. The CR Touch is currently wired with YELLOW to LCD pin 3 (Servo pin 27), WHITE to J3 pin 8 (GND), BLUE to Z-min pin 3 (Signal), BLACK to Z-min pin 2 (+5V) and RED to Z-min pin 1 (GND). A good deal came my way and I am intrigued by the roller wheels instead of linear "glides" to move everything around - I suspect the rollers will be far smoother than the cheap linear bearings that usually come with these cheap printers.
The mainboard control board is made of abs material, light weight and high strength, which can be used to improve your image quality.
GOOD HEAT DISSIPATION: Supports 12-24V power input, and adopts high performance low on resistance MOS tube as the driver, with good heat dissipation and effectively solves the heating problem of the hot bed MOS tube. Before you check out, take a moment to check for coupons, and you'll save even more on anet a8 motherboard. In Marlin IDE, after the project opens and if everything looks like the image, you are ready to upload the firmware.I started feeling the same way as DarkTerritory, here, who started a forum post in 2018 with “K so I’m thinking abut trying to upgrade my old Anet A8 motherboard to Marlin.
Great Deal 
New Comment