250 x Insulation Retaining Discs Cavity Wall Tie 80mm Clips / Celotex Kingspan

Product Information

Insulation fixings and screws are vital for ensuring each type of insulation is secured properly. Using the correct hardware will make sure everything from plasterboard to multifoil stays in place and doesn’t get damaged. The stainless steel Insofast ISF18 is a similar fixing that includes an 18mm head. It is perfect for fixing plywood or OSB faced insulation sheets to rafters in warm flat roof appli­cations. The ISF18 is also available in zinc-plated steel. Non-combustible fixings for fastening insulation to concrete soffits Note: For heavy wall-mounted parts, use independent horizontal battens. You may also need longer fixings to fit heavy items to the masonry, separate from the battens. For any further information or prices please do call our national sales office. Buy Celotex Insulation fixings for fixing Pitched roof insulation currently unavailable How to install Celotex insulation for single timber frame wall lining and dormer cheeks What you need

Step one: Make sure walls are in a good condition and suitable for internal linings – take care to remove any vinyl wallpaper or gloss pain to leave the wall surface clean, dust-free and free from loose material(s). Ensure the wall is also dry, having any remedial work done prior to installation of the boards to remove dampness.Our securing pegs can be used to hold insulation away from your greenhouse walls. This creates an air space which helps retain and control the air temperature. Step three: Once the adhesive has set, it is advised that secondary fixings are applied to Celotex PL4000 – ensure fixing details are in line with fixing manufacturer recommendations.

Due to increased care being taken regarding insulation standards, today it’s important to ensure the target U-value set for properties is met with proper insulation. Step one: Make sure studs and rails are flush – no projections. Services must be correctly installed. Step five: Fix plasterboard lining over the vapour control layer using suitable plasterboard nails or screws.

Applications and Solutions

Step two: Where required, cut the assigned 1200mm x 2400mm board (Celotex PL4000 or Celotex GA4000) to ensure they fit floor-to-ceiling room height. Step one: Fit the Celotex insulation tightly using suitable mechanical fixings (in accordance with the manufacturer’s instructions). Step four: At the top and bottom of the wall, fix horizontal battens over the insulation to keep the insulation boards in place. Seal each board joint. There is a technical requirement for the use of insulation fixings during the installation of the external wall insulation (EWI). The selection of the optimal insulation fixings depend on the substrate. There are specialised types of insulation fixings: