Yealink W60B DECT Base Station - Black

Product Information

Connect the ethernet cable between the Internet port on the phone and the network port on a router or switch to access LAN. This step is not required for brand new out-of-the-box phones, however, if the phone has been already used then it is a must. NB * the log file is not in the directorty above its in the /var/log/3cxsbc directory not /var/log. The Yealink W60B/W70B is a DECT base station aimed at home as well as small and medium-sized businesses. Its main specifications are:

Docs/firmware from Yealink: https://support.yealink.com/en/portal/docList?archiveType=document&productCode=b0040cca269c2a01 Search for an entry by using the keypad to type letters, or press ▲ or ▼ to highlight the desired entry, and then press or to dial out using the default line. BT appears to have restricted the reset on the GUI but may not have considered all the scenarios of the connect button reset.The Yealink W60B is the DECT IP base station for small and medium-sized businesses. Paring with up to a total of 8 Yealink W56H DECT handsets, W60B allows you enjoy superb mobility and efficient flexibility immediately as well as significantly eliminates additional wiring troubles and charges. A powerful chip ensuring a better and higher performance, this DECT IP base station not only supports up to 8 VoIP accounts and 8 concurrent calls, but also speeds up its startup and signal connection, slashes its upgrade downtime as well. Connect the Base Station to the power using the cable provided. If you are using Power over Ethernet, you can skip this step. So until we forwarded the incoming port 5001 on our LAN to the SBC, the W60B phone could not auto-provision and that seems perfectly logical given the above.

I have brought the W60B phone into the office and reset the base and taken the steps above to add the Provisioning URL and provision to do the auto provisioning. If you need help then our team are available from Monday to Thursday (between 9:00am and 5:30pm GMT) and on Friday (between 9:00am and 4:30pm GMT) I followed through the instructions above. The Base reset Ok, and once the base reset the handset automatically said de-register the handset? on the screen, so i pressed yes. The set of instructions thereafter to deregister the handset therefore could not be followed to de-register the handset as described as it had already de-registered itself and said so. It couldn't therefore do the handset reset.

Video tutorial explaining Auto Provisioning setup for Yealink Phone on PBXware 5. ¶ Requirements ¶ Identifying phone model So i used a logical workaround: I then managed to reset the handset in settings which failed before and then pressed the connect button on the base and managed re-register the handset from settings it then paired ok. Clip the Base Stand onto the Base Station to allow it to stand up, or use screws drilled 59mm apart to mount onto a wall. Connect the Ethernet cable between the Internet port on the phone and an available port on the in-line power router or switch.

The PIN is used to register handsets to the base station, and for the handset to access settings from the base station. When a Base and a handset are supplied together in a single box, then the handset should already be registered to the base station. You can use these steps to register additional handsets though: You'll have to wait couple of seconds for the configuration to be updated. NOTE: Do not power off your phone.

Yealink W60B DECT IP Base Station Features:

Choose what server type you intend to use: HTTP, HTTPS and Trivial FTP. NOTE: Our recommendation is to use the HTTP. Features -> General Information -> Number Of Active Handsets --> Set to 8 (if you have more than 4 handsets) I must say, not being able to access the cPanel is a bit annoying, as you lose access to certain features – i.e. directory, codec settings, etc. Based on wireless DECT standard to offer premium and stable HD audio quality for efficient and clear communication.