Silverline Water Level 10m (633586)

Product Information

In case of water loss, refill and adjust the device. Colours on images on different devices may vary. We cannot guarantee an exact match of the colour to the product. The job of marking is best done between 2 people so that both ends can be marked, so bear this in mind. Step 2 – Prepare Water – Fill A suitable sized jug with water and add several drops of food colouring to to dye it. This will help to make it more visible in the tube Our collections by our couriers are happening as usual. As it stands, delivery times are not being affected too much. Please be aware though that Royal Mail and other couriers are sometimes prioritising essential items so please bear with us if your delivery takes slightly longer than expected.

When it comes to making your own water level, the type of tube is of high importance. You will need to ensure that it’s the correct length for your needs, so 50 – 70 feet should suffice and a diameter of 8 – 10mm will give enough movement for the water and allow a level to be clearly seen. Hold the hose ends at the same height. Allow the water level to equilibrate freely. Mark both levels of the surface of water on the hose.Put on the end plugs. They will prevent an outflow of water to the place of measurements. After reaching the measurement levels, remove the plugs.

Before you can actually start levelling items with your water level you will first have to make it, if you’re not buying one. Follow the steps below to do so: To save the job of making your own, you can actually buy a pre-made water level from most DIY stores such as the one below. However it is likely that it will cost a bit more than making one yourself.

Set Up And Using The Water Level

Step 4 – Move to Level – Once it is settled you have achieved a level point between both ends of the tube, you can then move it up or down until the fluid meets the height required. The other end of the pipe will be at the same height. You can then place your mark Toolty Water Level Gauge Kit is used for leveling points that are far apart. Measuring tubes with a readable scale are made out of durable plastic (PVC). Tight plugs prevent the outflow of water at the place of measurements. The tube is then filled with water, except for a few inches at either end and they will both settle at the same level regardless of how close or far they are apart.